Hyundai Tucson: Driveshaft Assembly / BJ Boot Repair procedures

Removal
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove the Dynamic damper.
(Refer to Driveshaft Assembly - “Dynamic Damper”)
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
   
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
7.
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
BJ Boot Components and Components Location
Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...

Rear Axle Assembly
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Variable Intake Solenoid (VIS) Valve Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Strut Assembly Components and Components Location
Components 1. Dust cover2. Upper mounting nut3. Self locking nut4. Insulator5. Spring upper pad6. Strut dust cover & Bumper rubber7. Coil spring8. Spring lower pad9. Piston rod10. Strut assembly11. Spring lower seat ...

© 2010-2024 www.htmanual.net