Hyundai Tucson: Tires/Wheels / Wheel Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures

Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque (Front) :

88.25 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Tightening torque (Rear) :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

Measure the wheel Run-out by using a dial indicator as illustration below.

Run-out	Aluminum	Steel
Radial mm(in.)	Below 0.3(0.012)	Below 1.0(0.039)
Axial mm(in.)	Below 0.3(0.012)	Below 0.6(0.024)

3.	If measured value exceeds the standard value, replace the wheel.

Tire Repair procedures

• Using tires and wheel other than the recommended sizes could cause unusual handling characteristics and poor vehicle control, resulting in a serious accident. Tire ...

Alignment Repair procedures

Front Wheel Alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a lev ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Good driving practices
Never move the shift lever from P (Park) or N (Neutral) to any other position with the accelerator pedal depressed. Never move the shift lever into P (Park) when the vehicle is in motion. Be sure the vehicle is completely stopped before you attempt to shift into R (Reverse) or D (Drive ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting SymptomSuspect AreaRemedyWater leaks from panoramaroof Deteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance andImproperly fitted weatherstripAdjustWind noise around sunroofLoose or deformed deflector, gapsIn body workRetighten adjust or replaceNoise hear ...