Hyundai Tucson: Tire Pressure Monitoring System / TPMS Sensor Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor Repair procedures

Removal

Tire Removal

Deflate tire & remove balance weights.

Sensor can be unscrewed before unseating the tire bead.

•	The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep.

•	Avoid tire/tool contact with the valve on dismount.

•	Dismount should end near the valve.

Sensor Removal

Handle the sensor with care.

Remove the valve nut.

The valve nut should not be re-used.

2.	Discard the valve assembly.

Installation

Sensor Fit

•	Handle the sensor with care.

•	Avoid lubricant contact.

•	Ensure that the wheel to be fitted is designed for sensor mount. There should normally be a mark to indicate this.

•	Ensure that the valve hole and mating face of the wheel are clean.

1.	Slide the sensor-valve unit through the valve hole of the rim. Hold the sensor against the rim and the rubber grommet against the sealing surface.

2.	Insert the nut over the valve stem and then tighten the nut.

Continue to tightening the nut until contact with the rim and then tighten to 3.5 ~ 4.5Nm.

-	Tighten slowly with quarter turn steps until the final torque is reached.

-	Do not exceed allowed torque.

-	Do not use electric or pneumatic tools.

Check that the sensor is firmly attached to the rim.

Risk of damage during the tire installation/ removal if the sensor is not firmly attached to the rim.

Adjustment

Diagnosis procedure by using diagnostic device

As manual for diagnosis methods by using diagnosis device, the main contents are as follows:

1.	Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.

2.	Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK. [Register Sensor initialization] [TPMS Mode Confiquration] [Sensor Status initialization]

TPMS Sensor Description and Operation

Description 1. Mode (1) Configuration State A. All sensors should be in the Low Line (Base) state. B. In Low Line (Base) configuration, sensor transmissions occur every 3 minutes 20 seco ...

TPMS Receiver Description and Operation

Description 1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. B. In this state, there is no sensor ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Audio Head Unit (for XM RADIOTM equipped model)
1. (EJECT) Ejects the disc. 2. Changes to FM/AM/XM mode. Each time the key is pressed, the mode is changed in order of FM1 ➟ FM2 ➟ AM ➟ XM1 ➟ XM2 ➟ XM3. ❈ In Setup>Display, the radio pop up screen will be displayed when [Mode Pop up] is turned . When the pop ...

Hyundai Tucson (LM) 2010-2015 Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. Removal Replacing an on/off soleno ...