Replacement |
When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is
used to replace the faulty part i.e. it must be Low Line and not High
Line in order to have the correct inflation warning thresholds set. |
1. |
Disconnect vehicle battery. |
2. |
Remove the glove box.
(Refer to Body - "Crash Pad") |
3. |
Remove faulty part and fit bracket assembly to new part. |
4. |
Secure new part to vehicle and fit connector. |
5. |
Re-connect battery and turn Ignition on. |
6. |
Check that TREAD Lamp flash rate matches Virgin State indication. |
Adjustment |
Diagnosis procedure by using diagnostic device |
1. |
Connect self-diagnosis connector(16pins) located in the lower
of driver side crash pad to self-diagnosis device, and then turn the
self-diagnosis device after key is ON. |
2. |
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
[Sensor ID Writing]
[Vehicle name input initialization]
[VIN input initialization] |
Hyundai Tucson (LM) 2010-2015 Service Manual: Interior Trim Repair procedures
Replacement
Door Scuff Trim Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the door sc ...
Hyundai Tucson (LM) 2010-2015 Service Manual: General Information
Identification Number Locations
Identification Number Description
Vehicle Identification Number
1.
World Manufacturer Identifier (WMI)
A.
KMF : Commercial vehicle (Van)
B.
KMH : Passenger vehicle or MPV(Multipurpose Passenger Vehicle)/SUV(Sports Utility Vehicle)/RV(Recreational Vehicle)
...