Removal |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pins (A) as arrow direction. And then remove the seat
belt after pushing the lock pin (B). |
3. |
Remove the following parts. (Refer to the Body group- Interior trim)
|
4. |
Remove the upper anchor bolt. |
5. |
Disconnect the Seat Belt Pretensioner connector. |
6. |
Loosen the Seat Belt Pretensioner mounting bolt and remove the Seat Belt Pretensioner. |
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Install the Seat Belt Pretensioner (BPT) with a bolt.
|
4. |
Connect the Seat Belt Pretensioner (BPT) connector. |
5. |
Install the upper anchor bolts.
|
6. |
Install the following parts. (Refer to the Body group- Interior trim)
|
7. |
Insert the seat belt to the anchor pretensioner.
|
8. |
Reconnect the battery negative cable. |
9. |
After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications
SPAS unitPowerIGN 1Operating voltage9V ~ 16VSPAS sensor (Front/Rear)Number of sensors4EA (Front), 4EA (Rear)Operation voltage 9V ~ 16VSupply current 0.5mA ~ 5mAOperation frequency 51.2 KhzDetecting range 2mDetection angle(horizontal) 75°Detection angle(V ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Control Shaft Assembly Repair procedures
Removal
1.
Remove the following items;
A.
Air cleaner assembly and air duct.
(Refer to "Intake and Exhaust system" in EM group.)
B.
Battery and battery tray.
(Refer to "Charging system" in EE group.)
Set room side Shift lever to N position before remove the cont ...