Hyundai Tucson: Seat Belt Pretensioner / Anchor Pretensioner Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Restraint / Seat Belt Pretensioner / Anchor Pretensioner Repair procedures

Removal

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	To remove the seat belt anchor pretensioner (C), keep on pushing the lock pins (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

Remove the following parts. (Refer to the Body group-Interior trim)

A.	Door scuff trim

B.	Center pillar trim

4.	Disconnect the anchor pretensioner connector (A).

5.	Loosen the anchor pretensioner mounting bolt (B) and remove the anchor pretensioner.

Installation

1.	Remove ignition key from the vehicle.

2.	Disconnect the negative (-) cable from battery and wait for at least three minutes.

Install the anchor pretensioner with a bolt.

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the anchor pretensioner connector.

Install the following parts. (Refer to the body group - Interior trim)

A.	Center pillar trim

B.	Door scuff trim

Insert the seat belt to the anchor pretensioner.

Make sure the lock pin is connected in properly.

7.	Reconnect the battery negative cable.

After installing the anchor pretensioner, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Anchor Pretensioner Components and Components Location

Components ...

Brake System

...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Caring for disc
If the temperature inside the car is too high, open the car windows to ventilate before using the system. It is illegal to copy and use MP3/WMA files without permission. Use CDs that are created only by lawful means. Do not apply volatile agents, such as benzene, or thinner, normal clea ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Locking
To lock : 1. Close all doors, engine hood and tailgate. 2. Either press the door handle button or press the Door Lock button (1) on the smart key. 3. The hazard warning lights will blink and the chime will sound once. 4. Make sure the doors are locked by checking the position of the door l ...