Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and 2. |
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B,C) from the fuel tank air filter and canister close valve. |
5. |
Remove the fuel tank air filter and canister close valve assembly (A) after removing the mounting nut (B). |
6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the airbag module mounting bolts (2EA).
3.
Remove the wiring fixing clip (C) and disconnect the horn connector (A).
4.
Release the connector locking pin, then discon ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Components
1. Receiver2. TPMS Sensor3. TPMS Sensor4. TPMS Sensor5. TPMS Sensor
...