Hyundai Tucson: Automatic Transaxle Control System / Shift Lever Repair procedures

Removal
1.
Pull the knob (A) in the direction of "F" and remove it, and then remove the console upper cover.

2.
Remove the console.
(Refer to Body - "Floor console")
3.
Disconnect the connector (A) from the shift lever.

4.
Disconnect the shift cable (A) from the shift lever.

5.
Remove the shift lever (A) after removing the bolts.

Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Installation
1.
Installation is the reverse of removal.
   
When installing, set room side Shift lever and T/M side manual control lever to N position.
Shift Lever Components and Components Location
Components 1. Shift lever knob 2. Shift lever assembly3. Shift cable4. Manual control lever5. Shift cable retainer ...

Shift Cable Components and Components Location
Components 1. Shift lever knob 2. Shift lever assembly3. Shift cable4. Manual control lever5. Shift cable retainer ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Power Seat Control Switch Repair procedures
Inspection 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the power seat recliner cover ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Seat Belt Buckle Switch (BS) Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and ...

© 2010-2024 www.htmanual.net