Hyundai Tucson: Blower / Intake Actuator Repair procedures

Inspection
1.
Ignition "OFF"
2.
Disconnect the intake actuator connector.
3.
Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 4.
4.
Verify that the intake actuator operates to the fresh position when connecting in the reverse.

1. -
2. –
3. Fresh
4. Recirculation
5. 5V (Vcc)
6. Feedback Signal
7. Sensor Ground

5.
Check the voltage between terminals 6 and 7.
Door position
Voltage(6-7)
Error detecting
Recircualtion
9.4 ± 0.15V
Low voltage : 0.1V or less
Fresh
4.6 ± 0.15V
High voltage : 4.9V or more

6.
If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation.
7.
If the problem is corrected, replace the intake actuator.
Replacement
1.
Disconnect the damper (A) from the glove box (B).

2.
Remove the glove box lift (C).

3.
Disconnect the pine, then remove the glove box (A).

4.
Remove the crash pad passenger panel (A).

5.
Remove the glove box housing (A).

6.
Remove the shower duct (A).

7.
Disconnect the Intake actuator connector (A).
8.
Loosen the mounting screw and then remove the intake actuator (B).

9.
Install in the reverse order of removal.
Intake Actuator Description and Operation
Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will shift between re ...

Controller
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Recommended lubricants and capacities
To help achieve proper engine and powertrain performance and durability, use only lubricants of the proper quality. The correct lubricants also help promote engine efficiency that results in improved fuel economy. *1 Refer to the recommended SAE viscosity numbers on the next page. *2 Engine ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Disc Brake Components and Components Location
Components 1. Guide rod bolt2. Bleed screw3. Caliper bracket 4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer ...

© 2010-2024 www.htmanual.net