Inspection |
1. |
Ignition "OFF” |
2. |
Disconnect the connector of mode control actuator. |
3. |
Verify that the mode control actuator operates to the defrost
mode when connecting 12V to the terminal 3and grounding terminal 4. |
4. |
Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
|
5. |
Check the voltage between terminals 5 and 6.
It will feedback current position of actuator to controls. |
6. |
If the measured voltage is not specification, substitute with a known-good mode control actuator and check for proper operation. |
7. |
If the problem is corrected, replace the mode control actuator. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad left side cover (A). |
3. |
Remove the extension cover(A) |
4. |
Remove the crash pad lower cover (A). |
5. |
Disconnect the diagnosis connector (A). |
6. |
Remove the reinforcing panel (A). |
7. |
Remove the shower duct (A). |
8. |
Disconnect the temperature control actuator connector (A). |
9. |
Loosen the mounting screw and then remove the temperature control actuator (B). |
10. |
Install in the reverse order of removal. |
Hyundai Tucson (LM) 2010-2015 Owners Manual: Turn signal light
1. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
2. Remove the bulb from the socket by pressing it in and rotating it counterclockwise
until the tabs on the bulb align with the slots in the socke ...
Hyundai Tucson (LM) 2010-2015 Service Manual: 4WD ECU Repair procedures
Replacement
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool.
(Refer to 4WD Control System - "Adjustment")
2.
Disconnect the battery negative cable from the battery
3.
Disconnect the 4WD ECU connector (A).
4.
Loosen the nust (A) and then remo ...