Hyundai Tucson: Maintenance / Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in your vehicle.
Your vehicle is equipped with an emission control system to meet all applicable emission regulations. There are three emission control systems, as follows.
(1) Crankcase emission control system
(2) Evaporative emission control system
(3) Exhaust emission control system
In order to assure the proper function of the emission control systems, it is recommended that you have your vehicle inspected and maintained by an authorized HYUNDAI dealer in accordance with the maintenance schedule in this manual.
CAUTION
For the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)
- To prevent the vehicle from misfiring during dynamometer testing, turn the Electronic Stability Control (ESC) system off by pressing the ESC switch (ESC OFF light illuminated).
- After dynamometer testing is completed, turn the ESC system back on by pressing the ESC switch again.
- 1. Crankcase emission control system
- 2. Evaporative emission control system including Onboard Refueling Vapor Recovery (ORVR)
- 3. Exhaust emission control system
Interior care
Interior general precautions
Prevent caustic solutions such as perfume and cosmetic oil, from contacting the
interior parts because they may cause damage or discoloration. If they do contact
the ...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase.
This system supplies fresh filtered air to the crankcase thr ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Propeller Shaft Repair procedures
Removal
1.
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.1 ~ 50.6 lb-ft)
2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).
Tightening to ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Fender Repair procedures
Replacement
•
When removing and installing the hood, an assistant is necessary.
•
Be careful not to damage the hood and body.
•
When removing the clips, use a clip remover.
1.
Remove the front bumper.
(Refer to Bumper - “Front Bunper” )
2. ...
