Hyundai Tucson: Automatic Transaxle Control System / Output Speed Sensor Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Description and Operation

Description

The Output Speed Sensor is a vital unit that measures the rate of rotation of the transmission's turbine shaft and output shaft, and delivers the readings to the TCM.

The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

Input Speed Sensor Repair procedures

Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. (R ...

Output Speed Sensor Specifications

Specifications x Type: Hall effect sensor Operation condition (°C)°F(-40~150) -40~302Air gap (mm)in.(0.25~0.70) 0.0098~0.0276Output voltage (V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: TPMS Sensor Repair procedures
Removal Tire Removal 1. Deflate tire & remove balance weights. Sensor can be unscrewed before unseating the tire bead. • The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Variable Intake Solenoid (VIS) Valve Description and Operation
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table). Engine condi ...