Hyundai Tucson: Automatic Transaxle Control System / Output Speed Sensor Repair procedures

Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.

Specification: Refer to "Signal Wave Form" section.

Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A) from the main wiring.
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
•
Adding Automatic Transaxle Fluid(ATF).
Output Speed Sensor Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation
Description Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque conv ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: In car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow air with changing temperature to the in car sensor air inlet. Measure sensor resistance between 1 and 2 terminals. 1. Sensor Ground2. Incar Sensor Signal Specification Temperature [°C(°F)] Resistance between terminals 1and 2 (kx)-20(-4)290.21-10(1 ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Power outlet
The power outlets are designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engine running. WARNING Avoid electrical shocks. Do not place your fingers or foreign objects (pin, ...

© 2010-2026 www.htmanual.net