Hyundai Tucson: Panoramic sunroof / Tilting the Sunroof

Open the roller blind before opening and closing the sunroof.

To tilt the sunroof open:

Push the sunroof control lever upward until the sunroof moves to the desired position.

To close the sunroof:

Pull the sunroof lever downward until the sunroof moves to the desired position.

WARNING

✽ NOTICE

After washing the vehicle or after a rain, be sure to wipe off the water on the sunroof before operating the sunroof.

CAUTION

To reset the sunroof

If the battery has been discharged or disconnected, or if the related fuse has been replaced or disconnected, reset the Sunroof as follows:

1. The ignition switch must be in the ON position.

2. Open the roller blind.

3. Close the sunroof completely.

4. Release the control lever.

5. Push the control lever forward until the sunroof tilts and slightly moves up and down. Then, release the lever.

6. Push the control lever forward until the sunroof is operated as follows:

TILT OPEN → SLIDE OPEN → SLIDE CLOSE

Then, release the control lever.

If the sunroof does not operate properly after resetting, have the system checked by an authorized HYUNDAI dealer.

Sliding the sunroof
Pressing the sunroof control lever backward or forward momentarily to the second detent position completely opens or closes the sunroof even when the switch is released. To stop the sunroof at the ...

Sunroof open warming
If the driver removes the ignition key (Smart key : turns off the engine) and opens the driver’s side door when the sunroof is not fully closed, the warning chime will sound for approximately ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil hydraulic Motor(Actuator) Description and Operation
Description The 4WD ECM controls the Pump Motor Pump (Actuator) to generating an oil pressure. The pressure engages a multiple disk clutch to transfer torque to the rear wheels. The torque to the rear wheels varies according to the pressure on the clutch. ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up. ...

© 2010-2026 www.htmanual.net