Hyundai Tucson: Normal maintenance schedule / 30,000 miles (48,000 km) or 24 months
- Rotating tires
- Inspect vacuum hose
- Inspect air conditioning refrigerant
- Inspect brake hoses and lines
- Inspect drive shafts and boots
- Inspect exhaust pipe and muffler
- Inspect front brake disc/pads, calipers
- Inspect propeller shaft (AWD)
- Inspect rear brake disc/pads
- Inspect steering gear box, linkage & boots/lower arm ball joint, upper arm ball joint
- Inspect suspension mounting bolts
- Inspect brake fluid
- Inspect fuel filter *2
- Inspect fuel lines, fuel hoses and connections
- Inspect fuel tank air filter (if equipped) *2
- Inspect parking brake
- Inspect vapor hose and fuel filler cap, fuel tank
- Replace climate control air filter (for evaporator and blower unit)
- Replace air cleaner filter
- Replace engine oil and filter (30,000 miles (48,000 km) or 48 months)
- Add fuel additive *1 (30,000 miles (48,000 km) or 48 months)
22,500 miles (36,000 km) or 18 months
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Replace engine oil and filter (22,500 miles (36,000 km) or 36 months)
Add fuel additive *1 (22,500 miles (36,000 km) or 36 mont ...
37,500 miles (60,000 km) or 30 months
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Inspect rear axle oil (AWD) *3
Inspect transfer case oil (AWD) *3
Replace engine oil and filter (37,500 miles (60,000 km) or ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: TPMS Receiver Description and Operation
Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no sensor monitoring and no DTC monitoring.
C.
The state indicates that platform specific parameters must ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Starter Repair procedures
Removal
1.
Disconnect the battery negative terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Disconnect the starter cable (A) from the B terminal on the solenoid then disconnect the connector from the S terminal (B).
4. ...
