Hyundai Tucson: AVN System / AVN Head Unit Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / AVN System / AVN Head Unit Repair procedures

Removal

•	Take care not to scratch the center fascia panel and related parts.

•	Eject all the disc before removing the AVN head unit to prevent damaging the CD player's load mechanism.

1.	Disconnect the negative (-) battery terminal.

Remove the hazard lamp switch assembly (A).

-	Take care not to damage and scratch the hazard lamp switch assembly and its related parts.

-	Apply the protective tapes to the hazard lamp switch assembly and its related parts.

3.	Disconnect the connectors (A).

4.	Remove the center fascia panel (A).

5.	Remove the audio assembly (A) after loosening the mounting screws.

Disconnect the head unit connectors and cable (A), then remove the AVN head unit completely..

-	When the compact disc is not ejected, do not remove it forcibly.

Installation

1.	Connect the AVN connectors and cable.

2.	Install the AVN head unit.

3.	Install the center facia panel.

4.	Install the hazard lamp switch assembly.

5.	Connect the negative (-) battery terminal.

AVN Head Unit Components and Components Location

Components AVN (A/V & Navigation) Head Unit Connector Connector Pin Information No.Connector AConnector BConnector C1-MM CAN High-2Parking V VIDEO--3Parking V GND--4Rear camera P groundStee ...

Multimedia Jack Schematic Diagrams

Circuit Diagram ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Parking Assist System Control Unit Specifications
Specifications ItemSpecificationUltrasonic sensorVoltage ratingDC 12 VDetecting range15.7 ~ 47.2 in (400 ~ 1200 mm)Operation voltageDC 9 ~ 16 VOperation currentMAX 300 mAOperation temperature-22°F ~ + 176°F (-30°C ~ + 80°C)Beam widthHorizontal : 100±5°(70cm), Vertical : 60±5°(50cm)Numbe ...

Hyundai Tucson (LM) 2010-2015 Service Manual: 4WD ECU Repair procedures
Replacement 1. Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool. (Refer to 4WD Control System - "Adjustment") 2. Disconnect the battery negative cable from the battery 3. Disconnect the 4WD ECU connector (A). 4. Loosen the nust (A) and then remo ...