Hyundai Tucson: Clutch System / Clutch Master Cylinder Repair procedures
| Removal |
Do not spill brake fluid on the vehicle; it may damage the
paint if brake fluid does contact the paint, wash it off immediately
with water.
|
| 1. |
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).
|
| 2. |
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
|
| 3. |
Remove the clutch master cylinder by turning it clockwise (A).
|
| Installation |
| 1. |
Installation is the reverse of removal.
|
Clutch Master Cylinder Components and Components Location
Components
1. Reverse hose2. Master cylinder3. Siller4. Member assembly5. Turn over spring6. Clutch switch7. Clutch arm8. Pedal pad9. Ignition lock switch10. Stopper
...
Clutch Release Cylinder Components and Components Location
Components
1. Union bolt2. Gasket3. Tube joint4. Clutch tube5. Valve plate6. Valve spring7. Bleeder screw8. Release cylinder9. Return spring10. Piston11. Boot12. Push rod
...
Other information:
Hyundai Tucson (LM) 2010-2015 Owners Manual: Seat Belt-Driver’s 3-point system with emergency locking retractor
To fasten your seat belt:
Pull the seat belt out of the retractor and insert the metal tab (1) into the
buckle (2). There will be an audible "click" when the tab locks into the buckle.
The seat belt automatically adjusts to the proper length after the lap belt portion
is adjusted manually ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finis ...
