Hyundai Tucson: Manual Transaxle Control System / Control Shaft Assembly Repair procedures

Removal
1.
Remove the following items;
A.
Air cleaner assembly and air duct.
(Refer to "Intake and Exhaust system" in EM group.)
B.
Battery and battery tray.
(Refer to "Charging system" in EE group.)
   
Set room side Shift lever to N position before remove the control shaft assembly.
2.
Separate the cable (A) from the control shaft after remove the pin (B) and washer (C).

3.
Remove the control shaft assembly after loosen the bolts.

Installation
1.
Installation is the reverse of removal.
   
•
When installing, set control shaft lever to neutral position.
•
When installing, apply the sealant as shown in the illustration.

Specified sealant : MS 721-40 or MS721-38

2.
After installling, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
Control Shaft Assembly Description and Operation
Description Control shaft assembly is mounted on the top of the manual transmission, and select & shift cable are equipped. Control shaft assembly is operated by shifting the shift lever. ...

Automatic Transaxle System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Pressure Sensor Description and Operation
Description The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque value varies according to a pressure status. ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Compressor Oil Repair procedures
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compress ...

© 2010-2026 www.htmanual.net