Hyundai Tucson: Manual Transaxle Control System / Control Shaft Assembly Repair procedures

Removal
1.
Remove the following items;
A.
Air cleaner assembly and air duct.
(Refer to "Intake and Exhaust system" in EM group.)
B.
Battery and battery tray.
(Refer to "Charging system" in EE group.)
   
Set room side Shift lever to N position before remove the control shaft assembly.
2.
Separate the cable (A) from the control shaft after remove the pin (B) and washer (C).

3.
Remove the control shaft assembly after loosen the bolts.

Installation
1.
Installation is the reverse of removal.
   
•
When installing, set control shaft lever to neutral position.
•
When installing, apply the sealant as shown in the illustration.

Specified sealant : MS 721-40 or MS721-38

2.
After installling, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
Control Shaft Assembly Description and Operation
Description Control shaft assembly is mounted on the top of the manual transmission, and select & shift cable are equipped. Control shaft assembly is operated by shifting the shift lever. ...

Automatic Transaxle System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Low tire pressure indicator
The low tire pressure indicator comes on for 3 seconds after the ignition switch is turned to the "ON" position. The low tire pressure indicator illuminates when one or more of your tires is significantly underinflated. The low tire pressure indicator will illuminate after it blinks for appr ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Brake fluid
Checking the brake fluid level Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake fluid, clean the area around the reservoir cap thoroughly to prevent brake ...

© 2010-2026 www.htmanual.net