Hyundai Tucson: Bumper / Front Bumper Repair procedures

Replacement
   
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover mounting bolts and clips.

2.
Remove the mounting clips.

3.
After loosening the front bumper side’s mounting screw and clip, then disconnect the side’s.

4.
Push the lock pin, disconnect the fog lamp connector (A).
5.
Remove the front bumper.

6.
Install in the reverse order of removal.
   
Make sure the connector is plugged in properly.
Replace any damage clips.
Front Bumper Components and Components Location
Components 1. Front bumper assembly2. Front bumper rail ...

Rear Bumper Components and Components Location
Components 1. Rear bumper assembly2. Rear bumper mounting bracket ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Using Voice Recognition
Starting Voice Recognition Shortly press the   key on the steering wheel remote controller Say a command. If prompt feedback is in [ON], then the system will say “Please say a command after the beep (BEEP)” If prompt feedback is in [OFF] mode, then the system will only say “(B ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine ...

© 2010-2025 www.htmanual.net