Hyundai Tucson: Body Dimensions / General Information

Hyundai Tucson (LM) 2010-2015 Service Manual / Body (Interior and Exterior) / Body Dimensions / General Information

General

1.	Basically, all measurements in this manual are taken with a tracking gauge.

2.	When a measuring tape is used, check to be sure there is no elongation, twisting or bending.

3.	For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual.

Measurement Method

Projected Dimensions

1.	These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions used for body alterations.

2.	If the length of the tracking gauge probes is adjustable, make the measurement by lengthening one probe by the amount equivalent to the difference in height of the two surfaces.

Actual-Measurement Dimensions

1.	These dimensions indicate the actual linear distance between measurement points, and are the reference dimensions for use if a tracking gauge is used for measurement.

Measure by first adjusting both probes to the same length (A=A').

Check the probes and gauge itself to make sure there is no free play.

Measurement Point

1.	Measurements should be taken at the hole center.

Front Body Body Repair

Front body A Front body B Front body C ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Brake Booster Components and Components Location
Components 1. Brake booster2. Master cylinder assembly3. O-ring ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Pressure Sensor Repair procedures
Inspection If you have trouble code related to the pressure sensor check pressure sensor according to the inspection process. Pressure Sensor Inspection Procedure Measure the resistance of pressure sensor 1. Turn ignition switch OFF. 2. Disconnect the pressure ...