Hyundai Tucson: Automatic Transaxle Control System / Inhibitor Switch Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Description and Operation

Description

Inhibiter Switch contains two contact points. One of these points connects the engine startup when the lever is in the N or P position and turns on the reverse lights. The other contact point monitors the lever's position (PRND) and is used to control gear setting signals.

SS-B Solenoid Valve(ON/OFF) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Inhibitor Switch Specifications

Specifications x Type: Combination of output signals from 4 terminals Power supply (V)12Output typePin to Pin Signal Code Table PP-RRR-NNN-DDS112V12V00000S2012V12V12V000S300012V12V12V0S ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Special Service Tools
Special Service Tools Tool (Number and Name)IIIustrationUse09568-34000Ball joint remover ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Clutch Cover And Disc Repair procedures
Removal 1. Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group) 2. Remove the clutch cover bolts. • Be careful not to be bent or twist bolts. • Loosen bolts in diagonal directions. Inspection 1. Inspect cover diaphr ...