Hyundai Tucson: Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve sensor connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.

(Refer to Hydraulic system - "Valve Body")

Line Pressure Control Solenoid Valve Schematic Diagrams

Circuit Diagram ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Description and Operation

Description 35R clutch control solenoid valve(35R/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 35R clutch. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Inspection Manual Transaxle Oil Inspection 1. Park the vehicle on a level ground and stop the engine. 2. Retighten the oil filler plug (A) with a new washer. 3. Check level with finger. Oil level must be up to fill the hole, if not, add oil until it runs over. ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Jump starting
Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt about how to properly jump start your vehicle, we strongly recommend that you have a service technician or towing service do it ...