Hyundai Tucson: Braking system / Power brakes

Your vehicle has power-assisted brakes that adjust automatically through normal usage.

If the engine is not running or is turned off while driving, the power assist for the brakes will not work.

You can still stop your vehicle by applying greater force to the brake pedal than typical. The stopping distance, however, will be longer than with power brakes.

When the engine is not running, the reserve brake power is partially depleted each time the brake pedal is applied. Do not pump the brake pedal when the power assist has been interrupted.

Pump the brake pedal only when necessary to maintain steering control on slippery surfaces.

WARNING

Take the following precautions:

Braking system
...

Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high pitched warning sound from your front or rear brakes. You may hear this sound come and go or it may occur whenever you ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: If you decide to pull a trailer?
Here are some important points if you decide to pull a trailer: Consider using a sway control.You can ask a trailer hitch dealer about sway control. Do not do any towing with your vehicle during its first 1,200 miles (2,000 km) in order to allow the engine to properly break in. Failure t ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Back-up Lamp Switch Repair procedures
Inspection 1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. When the shift lever is in reverse, there should be continuity. 3. If necessary, repair or replace the backup lamp switch. Replacement 1. ...

© 2010-2021 www.htmanual.net