Hyundai Tucson: Braking system / Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high pitched warning sound from your front or rear brakes. You may hear this sound come and go or it may occur whenever you depress the brake pedal.
Please remember some driving conditions or climates may cause a brake squeal when you first apply (or lightly apply) the brakes. This is normal and does not indicate a problem with your brakes.
CAUTION
To avoid costly brake repairs, do not continue to drive with worn brake pads.
✽ NOTICE
Always replace brake pads as complete front or rear axle sets.
Power brakes
Your vehicle has power-assisted brakes that adjust automatically through normal
usage.
If the engine is not running or is turned off while driving, the power assist
for the brakes will not work.
...
Parking brake
Always set the parking brake before leaving the vehicle, to apply:
■ Foot type
Firmly depress the brake pedal. Depress the parking brake pedal down as far as
possible.
■ Hand type
Fi ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.
2.
Check for continuity between the terminals.
3.
If continuity is not specified, replace the switch.
Removal
1.
Disconnect the negative (-) battery termin ...
Hyundai Tucson (LM) 2010-2015 Service Manual: 4WD ECU Repair procedures
Replacement
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool.
(Refer to 4WD Control System - "Adjustment")
2.
Disconnect the battery negative cable from the battery
3.
Disconnect the 4WD ECU connector (A).
4.
Loosen the nust (A) and then remo ...
