| Inspection |
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
| 2. |
Remove the front bumper cover.
(Refer to the BD group - "Front bumper") |
| 3. |
Connect positive (+) and negative (-) battery cables to
terminals 2 and 1 respectively to see that the washer motor runs and
water is pumped. |
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
|
Rear Washer Switch Repair proceduresHyundai Tucson (LM) 2010-2015 Service Manual: Battery Sensor Repair procedures
Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolt (B).
Installation
1.
Install in the reverse order of removal.
Battery sensor cable installation bolt:
21.6 ~ 32 ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Brake Pedal Repair procedures
Removal
1.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
2.
Pull down steering column shaft after removing bolts and nuts.
3.
Disconnect the stop lamp switch connector (A).
4.
Remove the brake pedal member mounting nuts (B).
Tightening torque:
16.7 ~ 25.5 N.m ( ...