Hyundai Tucson: Horn / Repair procedures

Removal
1.
Remove the front bumper.
(Refer to the BD group - "Front bumper")
2.
Remove the bolts and disconnect the horn connectors, then remove the low pitch horn (A).

Installation
1.
Install the horns after connecting the horn connectors.
2.
Install the front bumper.
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspection
1.
Remove the horn relay (A) from the engine room relay box.
2.
There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
3.
There should be no continuity between the No.30 and No.87 terminals when power is disconnected.

Adjustment
1.
Operate the horn, and adjust the tone to a suitable level by turning the adjusting screw.
   
Horn adjustment screw is automatically sealed with silicon sealant.
The shape and size of the applied sealant is variable and tails or dribbles are acceptable and not to be tampered with.

Components and Components Location
Component Location 1. Horn switch2. Horn relay (Engine room compartment)3. Horn (Low pitch)4. Clock spring ...

AVN System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Where are the air bags?
Driver’s and passenger’s front air bags Your vehicle is equipped with a Advanced Supplemental Restraint System (SRS) and lap/shoulder belts at both the driver and passenger seating positions. The SRS consists of air bags which are located in the center of the steering wheel and the passeng ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Display Settings
Press the  key Select [Display] through  TUNE knob or key   Select menu through  TUNE knob Mode Pop up [Mode Pop up]  Changes  / selection mode During On state, press the or  key to display the mode change pop up screen. Text Scroll [Text ...

© 2010-2026 www.htmanual.net