| Replacement |
| 1. |
After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).
|
| 2. |
Install in the reverse order of removal. |
| 1. |
Remove the covers (A), and remove the screws, then remove the assist handle (B).
|
| 2. |
Install in the reverse order of removal. |
| 1. |
After loosening the mounting screws, then remove the overhead console assembly (A).
|
| 2. |
Push the lock pin (A), disconnect the connectors (B).
|
| 3. |
Install in the reverse order of removal.
|
| 1. |
Using a screwdriver, remove the cover (A). |
| 2. |
After loosening the mounting screws, then remove the room lamp (B). |
| 3. |
Disconnect the connector (C).
|
| 4. |
Install in the reverse order of removal.
|
| 1. |
Using a screwdriver, remove the vanity lamp (A). |
| 2. |
Disconnect the connector (B).
|
| 3. |
Install in the reverse order of removal. |
|
| 1. |
Remove the following items.
|
| 2. |
Disconnect the cover (A) and ECM room mirror connector (B).
|
| 3. |
Disconnect the cover (A) and rain sensor connector (B).
|
| 4. |
Disconnect the wiring connector (A), mounting clips.
[Driver's]
[Passenger's]
|
| 5. |
Push the lower anchor (A) of second row seat belt into the second center row seat belt cover.
|
| 6. |
Disconnect the antenna connector (A).
|
| 7. |
Disconnect the connector (B). |
| 8. |
Disconnect the clips and then remove the roof trim (A).
|
| 9. |
Install in the reverse order of removal.
|
Roof Trim Components and Components Location
Interior Trim Components and Components LocationHyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the forward facing sensor.
3.
Head a light to the rearward looking sensor.
4.
The ECM should be darkened as soon as the rearward looking se ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Cylinder Head Repair procedures
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damaging the cylinder head, wait until the engine
coolant temperature drops below normal temperature (20°C [68°F])
before removin ...