| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the floor console upper cover (A) using the appropriate tool.
|
| 3. |
Remove the seat heater switch module (A).
|
| 4. |
Disconnect the driver and assist seat heater switch connector (A).
|
| 5. |
Check that continuity exists between the terminals after turning the driver seat heater switch ON.
|
| 6. |
Check that continuity exists between the terminals after turning the assist seat heater switch ON.
|
| 7. |
If the switch fails to operate, replace the driver and assist seat heater switch (A).
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the power window switch from rear door trim.
(Refer to BE group - "Power window switch")
|
| 3. |
Turn 2nd seat heater switch ON and check that continuity exists between the terminals.
|
| 4. |
If the switch fails to operate, replace the 2nd seat heater switch.
|
Power Seat Control Switch Repair procedures
Seat Heater Components and Components LocationHyundai Tucson (LM) 2010-2015 Service Manual: TPMS Receiver Schematic Diagrams
Schematic diagram
Connector Information
PinDescription1Battery2CAN_High3GND4-5-6-7IGN8CAN_Low9-10-11-12-
...
Hyundai Tucson (LM) 2010-2015 Owners Manual: Seat belt safety precautions
Always fasten your seat belt and make sure all passengers have fastened their
seat belts before starting any trip. Air bags are designed to supplement the seat
belt as an additional safety device, but they are not a substitute. Most states
require all occupants of a vehicle to wear seat belts. ...