Hyundai Tucson: General Information / Specifications

Hyundai Tucson (LM) 2010-2015 Service Manual / Manual Transaxle System / General Information / Specifications

Specifications

Manual transaxle type		M6CF4
Engine type		Gasoline 2.0 GDI
Gear ratio	1st	3.769
	2nd	2.080
	3rd	1.387
	4th	1.079
	5th	0.884
	6th	0.744
	Reverse	3.077
Final gear ratio	1st ~ 6th	4.533
Final gear ratio	Reverse	5.231

Tightening Torques

Items	N.m	kgf.m	lb-ft
Oil drain plug	58.9 ~ 78.5	6.0 ~ 8.0	43.4 ~ 57.8
Oil filler plug	58.9 ~ 78.5	6.0 ~ 8.0	43.4 ~ 57.8
Shift lever assembly bolt	8.8 ~ 13.7	0.9 ~ 1.4	6.5 ~ 10.1
Control shaft complete	24.5 ~ 29.4	2.5 ~ 3.0	18.1 ~ 21.7
Control cable bracket bolt	14.7 ~ 21.6	1.5 ~ 2.2	10.9 ~ 15.9
Back up lamp switch	39.2 ~ 58.9	4.0 ~ 6.0	28.9 ~ 43.4
Transaxle support bracket bolt	58.9 ~ 78.5	6.0 ~ 8.0	43.4 ~ 57.8
Under cover installation bolt	6.9 ~ 10.8	0.7 ~ 1.1	5.1 ~ 8.0
Clutch release cylinder installation nut	14.7 ~ 21.6	1.5 ~ 2.2	10.9 ~ 15.9
Retainer installation nut	7.8 ~ 11.8	0.8 ~ 1.2	5.8 ~ 8.7
Start motor installation bolt	49.0 ~ 63.7	5.0 ~ 6.5	36.2 ~ 47.0
Roll rod support bracket bolt	49.0 ~ 63.7	5.0 ~ 6.5	36.2 ~ 47.0
Roll rod support bracket bolt	107.9 ~ 127.5	11.0 ~ 13.0	79.6 ~ 94.1
Transaxle upper mounting bolt (TM=>ENG)	42.2 ~ 53.9	4.3 ~ 5.5	31.1 ~ 39.8
Transaxle lower mounting bolt (ENG=>TM)	42.2 ~ 48.1	4.3 ~ 4.9	31.1 ~ 35.4
Transaxle lower mounting bolt (ENG=>TM)	42.2 ~ 53.9	4.3 ~ 5.5	31.1 ~ 39.8

Lubricants and Sealant

Items	Specified lubricant	Quantity
Transaxle gear oil	SAE 75W/85, API GL-4	1.9 ~ 2.0 L (0.50 ~ 0.53 U.S.gal., 2.01 ~ 2.11 U.S. qt., 1.67 ~ 1.76 lmp qt.)
Surface of release fork and bearing	Grease (CASMOLY L9508)	As requried

Sealant

Items	Specified sealant
Control shaft assembly	MS721-40 or MS721-38

Special Service Tools

Special Service Tools Tools(Number and name)IllustrationUse09200-3N000Engine support fixture(Beam)Removal and installation of the transaxle.Use this beam (SST No. : 09200-38001/09200-3N000) with ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: BJ Boot Repair procedures
Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Remove the Dynamic damper. (Refer to Driveshaft Assembly - “Dynamic Damper”) 4. Using a plier ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Power Window Switch Repair procedures
Inspection Main Power Window Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim and power window switch. (Refer to the BD group - "Front door") 3. Check for continuity between the terminals in each switch position according to the table. ...