Hyundai Tucson: Driveshaft Assembly / BJ Boot Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Removal

1.	Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

2.	Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”)

3.	Remove the Dynamic damper. (Refer to Driveshaft Assembly - “Dynamic Damper”)

4.	Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.	Remove the BJ boot.

Install in the reverse order of removal.

•	Do not disassemble the BJ assembly.

•	Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•	The boot band should be replaced with a new one.

7.	Check the front alignment. (Refer to Suspension System - "Front Alignment")

BJ Boot Components and Components Location

Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...

Rear Axle Assembly

...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Upper Arm Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the rear wheel & tire. 2. Loosen the bolt & nut and then remove the rear upp ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Battery Specifications
Specifications Battery ItemSpecificationModel typeCMF68L-BCICapacity [20HR / 5HR] (AH)68 / 54 Cold Cranking Amperage (A)600 (SAE) / 480 (EN)Reserve Capacity (Min)113 ...