Hyundai Tucson: Automatic Transaxle Control System / SS-A Solenoid Valve(ON/OFF) Description and Operation

Description
SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body.

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

SS-A Solenoid Valve(ON/OFF) Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) x Control type : Normal low type Control pressure kpa (kgf/cmx, psi)490.33(5.0, 71.12) Internal resistance(x)10 ~ 11 ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Brake Pedal Repair procedures
Removal 1. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 2. Pull down steering column shaft after removing bolts and nuts. 3. Disconnect the stop lamp switch connector (A). 4. Remove the brake pedal member mounting nuts (B). Tightening torque: 16.7 ~ 25.5 N.m ( ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Driver selectable steering mode (if equipped)
The Driver Selectable Steering Mode controls steering effort as driver's preference or road condition.You can select the desired steering mode by pressing the driver selectable steering mode button. The driver selectable steering mode stays in the last mode selected when turning the engine ...

© 2010-2020 www.htmanual.net