| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic system - "Valve Body") |
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Schematic Diagrams
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description and OperationHyundai Tucson (LM) 2010-2015 Owners Manual: Fuel filler door
Opening the fuel filler door
The fuel filler door must be opened from inside the vehicle by pulling up the
fuel filler door opener lever.
1. Turn the engine off.
2. Pull the fuel filler door opener lever up located on the floor, left side
of the driver’s seat.
✽ NOTICE
If the fuel f ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Component Location
1. Hood switch2. Burglar horn3. BCM & RF receiver4. Key warning switch5. Front door switch6. Front door lock actuator & switch7. Rear door lock actuator & switch8. Rear door switch9. Liftgate lid switch
1. Antenna2. BCM connector3. Antenna bracket
...