Hyundai Tucson: Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.

(Refer to Hydraulic system - "Valve Body")

26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams

Circuit Diagram ...

Line Pressure Control Solenoid Valve Description and Operation

Description line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Passive Occupant Detection System (PODS) Components and Components Location
Components 1. Sensor mat2. PODS Uint ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Front seat warmers (if equipped)
While the engine is running, push either of the switches to warm the driver's seat or front passenger's seat. During mild weather or under conditions where the operation of the seat warmer is not needed, keep the switches in the OFF position. Each time you push the switch, the temperature ...