Hyundai Tucson: Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams

Circuit Diagram

26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Specifications Direct control VFS[26/B] x Control type : Normal low type Control Pressure kpa (kgf/cmx, psi) 9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal resis ...

26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Buzzer Repair procedures
Inspection Test the buzzer by connecting battery voltage to the 1 terminal and ground the 2 terminal. The buzzer should make a sound. If the buzzer fails to make a sound, replace it.Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Recommended SAE viscosity number
CAUTION Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining any lubricant. This is especially important in dusty or sandy areas and when the vehicle is used on unpaved roads. Cleaning the plug and dipstick areas will prevent dirt and gr ...

© 2010-2025 www.htmanual.net