Hyundai Tucson: Automatic Transaxle Control System / Input Speed Sensor Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Description and Operation

Description

Input Speed Sensor is a vital unit that measures the rate of rotation of the input shaft inside the transmission and delivers the readings to the TCM.

The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

Transaxle Oil Temperature Sensor Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that ...

Input Speed Sensor Specifications

Specifications x Type: Hall effect sensor Operation condition (°C)°F((-)40~150)) -40~302Air gap (mm)in.(0.95~1.65) 0.0374~0.0649Output voltage(V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Purge Control Solenoid Valve (PCSV) Description and Operation
Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in th ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal [M/T] ECM Terminal Function (M/T) Connector [C200-MA] Pin No.DescriptionConnected to1Injector (Cylinder #3) [High] control outputInjector (Cylinder #3)2Injector (Cylinder #4) [High] control outputInjector (Cylinder #4)3Injector (Cylinder #2) [Low] contro ...