Hyundai Tucson: Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector (A).

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Removal

1.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air cleaner")

2.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

3.	Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

4.	Remove the valve body. (Refer to Hydraulic System - "Valve Body")

5.	Disconnect the solenoid valve connector (A).

6.	Remove the solenoid valve main connector mounting clip (A) after removing the bolt.

7.	Remove the solenoid valve main connector (A).

8.	Disconnect the input & output speed sensor connector (A) after press the lock from the solenoid valve main wiring.

9.	Remove the solenoid valve main wiring&oil tempreature sensor after loosening the main connctor bolt (A).

Installation

Install in the reverse order of removal.

•	Replace the valve body gasket (A) before reinstalling the valve body cover.

•	Adding automatic transaxle fluid. (Refer to Hydraulic system - "Fluid")

•	Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup. (Refer to Automatic transaxle control system - "Repair procedures" )

Transaxle Oil Temperature Sensor Schematic Diagrams

Circuit Diagram ...

Input Speed Sensor Description and Operation

Description Input Speed Sensor is a vital unit that measures the rate of rotation of the input shaft inside the transmission and delivers the readings to the TCM. The sensor prov ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Inhibitor Switch Description and Operation
Description Inhibiter Switch contains two contact points. One of these points connects the engine startup when the lever is in the N or P position and turns on the reverse lights. The other contact point monitors the lever's position (PRND) and is used to control gear setting signals. ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Rear seats
Seatback angle To recline the seatback: 1. Pull up the seatback lever. 2. Hold the lever and adjust the seatback to the position you desire. 3. Release the lever and make sure the seatback is locked in place. (The lever MUST return to its original position for the seatback to lock.) Foldin ...