| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic system - "Valve Body") |
35R Clutch Control Solenoid Valve(35R/C_VFS) Schematic Diagrams
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description and OperationHyundai Tucson (LM) 2010-2015 Owners Manual: Hill-Start Assist Control (HAC)
The Hill-Start Assist Control (HAC) prevents the vehicle from rolling backwards
when starting a vehicle from a stop on a hill. The system operates the brakes automatically
for approximately 2 seconds and releases the brake when the accelerator pedal is
depressed or after 2 seconds.
WARNING
A ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Propeller Shaft Components and Components Location
Components
1. Front propeller shaft2. Center bearing bracket3. Rear propeller shaft
...