Hyundai Tucson: Normal maintenance schedule / 75,000 miles (120,000 km) or 60 months
- Rotating tires
- Inspect air cleaner filter
- Inspect vacuum hose
- Inspect air conditioning refrigerant
- Inspect brake hoses and lines
- Inspect drive shafts and boots
- Inspect exhaust pipe and muffler
- Inspect front brake disc/pads, calipers
- Inspect propeller shaft (AWD)
- Inspect rear brake disc/pads
- Inspect steering gear box, linkage & boots/lower arm ball joint, upper arm ball joint
- Inspect suspension mounting bolts
- Inspect rear axle oil (AWD) *3
- Inspect transfer case oil (AWD) *3
- Inspect drive belts (First, 60,000 miles (96,000 km) or 72 months after every 15,000 miles (24,000 km) or 24 months)*5
- Replace climate control air filter (for evaporator and blower unit)
- Replace engine oil and filter (75,000 miles (120,000 km) or 120 months)
- Add fuel additive *1 (75,000 miles (120,000 km) or 120 months)
67,500 miles (108,000 km) or 54 months
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Replace engine oil and filter (67,500 miles (108,000 km) or 108 months)
Add fuel additive *1 (67,500 miles (108,000 km) or 108 ...
82,500 miles (132,000 km) or 66 months
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Replace engine oil and filter (82,500 miles (132,000 km) or 132 months)
Add fuel additive *1 (82,500 miles (132,000 km) or 132 ...
Other information:
Hyundai Tucson (LM) 2010-2015 Owners Manual: Electronic brake force distribution (EBD) system warning light
If these two warning lights illuminate at the same time while driving, your vehicle
may have a malfunction with the ABS and EBD system.
In this case, your ABS and regular brake system may not work normally. Have the
vehicle checked by an authorized HYUNDAI dealer as soon as possible.
WARNING ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal waveform
This example shows a typical Crankshaft Position Sensor(CkPS)
and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls
the injection and ignition timing by using these signals.
Generally CkPS signal is used to detect the piston's position
and CMPS signal is use ...
