Hyundai Tucson: Air Conditioning System / A/C Pressure Transducer Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Repair procedures

Inspection

1.	Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals.

Inspect the voltage value whether it is sufficient to be regular value or not.

Voltage = 0.00878835 * Pressure + 0.5 [PSIA]

3.	If the measured voltage value is not specification, replace the A/C pressure transducer.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Recover the refrigerant with a recovery/charging station.

Disconnect the dual pressure switch connector (3P) (A).

Tightening torque:

10 ~ 12 N.m (1.0 ~ 1.2 kgf.m, 7.4 ~ 8.8 lb-ft)

Take care that liquid & suction pipe are not bent.

4.	Install in the reverse order of removal.

A/C Pressure Transducer Description and Operation

Description A/C pressure transducer convert the pressure value of high pressure line into voltage value after measure it. By converted voltage value, engine ECU controls cooling fan by operatin ...

Evaporator Temperature Sensor Description and Operation

Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil Pump Repair procedures
Removal and Installation 1. Remove the timing chain cover. (Refer to Timing system in this group) 2. Remove the oil pump cover (A). Tightening torque Screws : 5.9 ~ 8.8 N.m (0.6 ~ 0.9 kgf.m, 4.3 ~ 6.5 lb-ft) Bolts : 8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft) 3. Remove ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Back-up Lamp Switch Repair procedures
Inspection 1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. When the shift lever is in reverse, there should be continuity. 3. If necessary, repair or replace the backup lamp switch. Replacement 1. ...