Hyundai Tucson: Heating, Ventilation and Air Conditioning / Air Conditioning System
- General Safety Information and Caution
- Description and Operation
- Repair procedures
- Components and Components Location
- Compressor Oil Repair procedures
- Refrigerant line Components and Components Location
- Refrigerant line Repair procedures
- Compressor Components and Components Location
- Compressor Repair procedures
- Condenser Components and Components Location
- Condenser Repair procedures
- Receiver-Drier Repair procedures
- A/C Pressure Transducer Components and Components Location
- A/C Pressure Transducer Description and Operation
- A/C Pressure Transducer Repair procedures
- Evaporator Temperature Sensor Description and Operation
- Evaporator Temperature Sensor Repair procedures
- In car sensor Description and Operation
- In car sensor Repair procedures
- Photo Sensor Description and Operation
- Photo Sensor Repair procedures
- Ambient Sensor Description and Operation
- Ambient Sensor Repair procedures
- Cluster Ion Generator Components and Components Location
- Cluster Ion Generator Description and Operation
- Cluster Ion Generator Repair procedures
Special Service Tools
Special Service Tools
Tool (Number and name)IllustrationUse09977-29000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly.
...
General Safety Information and Caution
Instructions
When Handling Refrigerant
1.
R-134a liquid refrigerant is highly volatile. A drop on the
skin of your hand could result in localized frostbite. When handling the
refrigerant, be ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Heater Core Repair procedures
Replacement
1.
Remove the crash pad.
(Refer to Heater - "Heater Unit")
2.
Loosen the mounting screw and then remove the heater core cover (A).
3.
Remove the heater core.
4.
Be careful that the inlet and outlet pipe are not bent during heater core removal, and pull out the heater co ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
4.
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
5.
Check that the resistance is within the specification.
Specifica ...