Hyundai Tucson: General Information / Special Service Tools
| Special Service Tools |
| Tool(Number and Name) | Illustration | Use |
| 09495-3K000 Band installer |
| Installation of ear type boot band |
| 09495-33000 Puller |
| Removal of spider assembly from a drive shaft. |
| 09530-2W100 Differential side oil seal installer |
| Installation of the differential side oil seal. (Use with 09231-H1100) |
| 09530-2W200 Removing plate |
| Removal of the pinion drive inner bearing. |
| 09530-2W300 Pinion drive shaft lock holder |
| Pinion drive shaft lock nut. |
| 09530-2W400 Pinion drive shaft lock installer |
| Pinion height measuring gauge. |
| 09530-2W600 Pinion height gauge (3 piece set) |
| Pinion height measuring gauge. |
| 09530-2W700 Pinion oil seal installer |
| Installation of the pinion oil seal installer. (Use with 09231-H1100) |
| 09527-4A000 Removing plate |
| Removal of the differential carrier assembly inner bearing. |
| 09532-11500A Bearing outer race installer |
| Installation of the bearing outer race. (Use with 09500-11000) |
| 09453-02100 Bearing installer |
| Installation of the differential carrier assembly inner bearing. |
| 09431-26200 Pinion drive outer bearing race installer |
| Installation of the pinion drive outer bearing race. (Use with 09231-H1100) |
| 09530-3T300 Differential assembly warking stand |
| Removal & Installation of the differential assembly warking stand. |
| 09231-H1100 Bar |
| Use with 9530-2W100, 09530-2W700, 09431-26200. |
| 09500-11000 Bar |
| Use with 9532-11500A. |
| 09568-34000 |
| Ball joint remover |
Specifications
Specification
ItemsInner sideOuter sideFront driveshaftJoint typeTJBJMax. permissible angle23.5°46.5°Rear driveshaftJoint typeTJBJMax. permissible angle23.5°46.5°Rear differentialOil typeHypo ...
Troubleshooting
Troubleshooting
Trouble SymptomProbable causeRemedyVehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceDefective front suspension and st ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switc ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Blower Motor Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation.
3.
If the problem is corrected, replace the blower motor.
Replacement
1.
Di ...