Passengers should not move out of or change seats while the vehicle is moving. A passenger who is not wearing a seat belt during a crash or emergency stop can be thrown against the inside of the vehicle, against other occupants, or be ejected from the vehicle.
Do not use any accessories on seat belts.
Devices claiming to improve occupant comfort or reposition the seat belt can reduce the protection provided by the seat belt and increase the chance of serious injury in a crash
Do not modify the front seats.
Modification of the front seats could interfere with the operation of the supplemental restraint system sensing components or side air bags.
Do not place items under the front seats.
Placing items under the front seats could interfere with the operation of the supplemental restraint system sensing components and wiring harnesses.
Do not cause impact to the doors.
Impact to the doors when the ignition switch is in the ON position may cause the air bags to inflate.
Modifications to accommodate disabilities.
If you require modification to your vehicle to accommodate a disability, contact the HYUNDAI Customer Connect Center at 1-877- 378-8727.
Adding equipment to or modifying your air bag equipped vehicle
If you modify your vehicle by changing your vehicle's frame, bumper system, front end or side sheet metal or ride height, this may affect the operation of your vehicle's air bag system.
Hyundai Tucson (LM) 2010-2015 Service Manual: Passenger Airbag (PAB) Module Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing. (Refer to the Body group- crash pad).
3.
Disconnect the passenger airbag connector and remove the PAB mounting bolt.
4.
Remove the crash pad. ( ...
Hyundai Tucson (LM) 2010-2015 Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to “Specification”
ETC Motor
1.
Turn the ignition switch OFF.
2.
Disco ...