Hyundai Tucson: Immobilizer System / Antenna Coil Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A).
[LHD]

[RHD]

   
Take care not to damage and scratch the shrouds and its related parts.
Take care not to damage the hook when removing the upper and lower shrouds.
3.
Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.

Installation
1.
Install the coil antenna and connect the 6P connector.
2.
Install the steering column upper and lower shrouds.
Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the steering column assembly. (Refer to the ...

Troubleshooting
Diagnosis Of Immobilizer Faults - Communication between the ECM and the SMARTRA. - Function of the SMARTRA and the transponder. - Data (stored in the ECM related to the immobilizer func ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Input Speed Sensor Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Special Service Tools
Special Service Tools Tools(Number and name)IllustrationUse09200-3N000Engine support fixture(Beam)Removal and installation of the transaxle.Use this beam (SST No. : 09200-38001/09200-3N000) with the supporter (SST No. : 09200-2S000).09200-2S000Engine support fixture(Adapter)Removal and installa ...

В© 2010-2026 www.htmanual.net