Hyundai Tucson: Warnings and indicators / AWD LOCK indicator (if equipped)
The AWD LOCK indicator light is illuminated when the AWD LOCK button is pushed. The purpose of this AWD LOCK mode is to increase the drive power when driving on wet pavement, snow-covered roads and/or off-road.The AWD LOCK indicator light is turned off by pushing the button again.
CAUTION
Do not use AWD LOCK mode on dry paved roads or highway, it can cause noise, vibration or damage of AWD related parts.
AWD system warning light (if equipped)
When the ignition switch is turned to the ON position, the AWD indicator will
illuminate and then go off in a few seconds.
If the AWD system warning light illuminates, this indicates that there i ...
Low tire pressure indicator
The low tire pressure indicator comes on for 3 seconds after the ignition switch
is turned to the "ON" position.
The low tire pressure indicator illuminates when one or more of your tires is
si ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Yaw-rate and G Sensor Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console.
3.
Disconnect the yaw rate & lateral & Longitudinal G sensor connector (A).
4.
Remove the mounting bolts (B).
Tightening torque:
7.9 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Canister Repair procedures
Removal
1.
Remove the fuel tank.
(Refer to "Fuel tank" in FL group.)
2.
Disconnect the vapor tube quick-connector (A,B) and the ventilation hose (C).
3.
Remove the canister in the direction of an arrow after removing the installation screws (D).
Inspection
1.
Check for the follow ...
