| Troubleshooting |
| Symptom | Suspect Area | Remedy |
| Water leaks from panoramaroof | Deteriorated roof lid weatherstrip | Replace |
| Excessive roof lid-to-body clearance andImproperly fitted weatherstrip | Adjust | |
| Wind noise around sunroof | Loose or deformed deflector, gapsIn body work | Retighten adjust or replace |
| Noise heard when opening/ closing panoramaroof | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
| Loose guide rails and lid | Retighten | |
| Motor runs but sunroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
| Incorrect engagement of motor pinion with drive cable | ||
| Decrease in motor`s clutch slipping force | ||
| Increased sunroof sliding resistance or interference of sunroof
with drive cables, weatherstrip, etc. due to maladjustment of sunroof | ||
| Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed is not an unusual noise | Incorrect engagement of motor pinion with drive cable | Check pinion installation and retighten motor |
| Worn out or damaged motor pinion bearing | Replace motor assembly | |
| Worn out or deformed drive cable | Replace | |
| Door glass fails to operateUp and Down | Incorrect window glass installation | Adjust position |
| Damaged or faulty regulator arm or regulator | Correct or replace | |
| Door does not open or closecompletely | Incorrect door installation | Adjust position |
| Defective door check assembly | Correct or replace | |
| Door hinge requires grease | Apply grease | |
| Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
| Incorrectly installed hood | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leak through windshield and rear window | Defective seal | Fill with sealant |
| Defective flange | Correct |
Special Service Tools
Body DimensionsHyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The measured resistance at high temperature after vehicle
running may be high or low. So all resistance must be measured at
ambi ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Power Window Switch Repair procedures
Inspection
Main Power Window Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door")
3.
Check for continuity between the terminals in each switch
position according to the table. ...