Hyundai Tucson: Trip computer / Warnings and indicators
All warning lights are checked by placing the ignition switch in the ON position (do not start the engine).
Any light that does not illuminate should be checked by an authorized HYUNDAI dealer.
After starting the engine, check to make sure that all warning lights are off. If any are still on, this indicates a situation that needs attention.
- Active ECO system (if equipped)
- Air bag warning light
- Anti-lock brake system (ABS) warning light
- Electronic brake force distribution (EBD) system warning light
- Parking brake & brake fluid warning light
- Seat belt warning
- Turn signal indicator
- Light on indicator
- High beam indicator
- Front fog light indicator (if equipped)
- Engine oil pressure warning light
- Charging system warning light
- Door ajar warning light
- Tailgate open warning light
- Sunroof Open Warning Light (if equipped)
- Low fuel level warning light
- Immobilizer indicator (if equipped)
- Malfunction indicator (MIL) (check engine light)
- ESC indicator (Electronic Stability Control)
- ESC OFF indicator
- DBC (Downhill brake control) indicator
- AWD system warning light (if equipped)
- AWD LOCK indicator (if equipped)
- Low tire pressure indicator
- Engine coolant temperature warning light (if equipped)
- Electric power steering (EPS) system warning light
- Cruise indicator (if equipped)
- Cruise SET indicator (if equipped)
- KEY OUT indicator (if equipped)
- Key reminder warning chime
Trip Modes
Push the button to select the following modes:
Tripmeter
This mode indicates the distance of individual trips selected since the last
tripmeter reset.
The meter's working range ...
Active ECO system (if equipped)
When the active ECO is operating, the ECO indicator is green.
WARNING
Do not continuously monitor the indicator while driving. It may distract you
while driving and may cause an accident that re ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Mode Control Actuator Repair procedures
Inspection
1.
Ignition "OFF”
2.
Disconnect the connector of mode control actuator.
3.
Verify that the mode control actuator operates to the defrost
mode when connecting 12V to the terminal 3and grounding terminal 4.
4.
Verify that the mode control actuator operates to the vent mo ...
Hyundai Tucson (LM) 2010-2015 Owners Manual: Using Voice Recognition
Starting Voice Recognition
Shortly press the key on
the steering wheel remote controller Say a command.
If prompt feedback is in [ON], then the system will say “Please say a command
after the beep (BEEP)”
If prompt feedback is in [OFF] mode, then the system will only say “(B ...
