Hyundai Tucson: Warnings and indicators / DBC (Downhill brake control) indicator

The DBC indicator will illuminate when the DBC button is pressed and the system is on.

When driving down a steep hill at a speed under 22 mph (35 km/h), the DBC will activate and the DBC indicator will blink to indicate the DBC is operating.

If the red indicator illuminates, the DBC system may have malfunctioned. Take your vehicle to an authorized HYUNDAI dealer and have the system checked.

ESC OFF indicator
The ESC OFF indicator will illuminate when the ignition switch is turned ON, but should go off after approximately 3 seconds. To switch to ESC function off, press the ESC OFF button. The ESC OFF ...

AWD system warning light (if equipped)
When the ignition switch is turned to the ON position, the AWD indicator will illuminate and then go off in a few seconds. If the AWD system warning light illuminates, this indicates that there i ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Key ignition switch
WARNING NEVER turn the ignition switch to the LOCK or ACC position while the vehicle is in motion except in an emergency. This will result in the engine turning off and loss of power assist for the steering and brake systems. This may lead to loss of directional control and braking functi ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Yaw-rate and G Sensor Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the floor console. 3. Disconnect the yaw rate & lateral & Longitudinal G sensor connector (A). 4. Remove the mounting bolts (B). Tightening torque: 7.9 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m ...

© 2010-2020 www.htmanual.net