Hyundai Tucson: Cooling System / Water pump Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Mechanical System / Cooling System / Water pump Repair procedures

Removal and Installation

1.	Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster.

2.	Remove the drive belt. (Refer to Timing system in this group)

Remove the water pump pulley (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Remove the water pump assembly (A) with the gasket (B).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation is reverse order of removal

Install a new water pump gasket.

6.	Fill the engine coolant.

7.	Start the engine and check for leaks.

8.	Recheck the coolant level.

Inspection

1.	Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.

2.	Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.

Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly.

A small amount of "weeping" from the bleed hole is normal.

Water pump Components and Components Location

Components 1. Water pump pulley2. Water pump3. Water pump gasket4. Water inlet fitting5. Thermostat6. Water temperature control assembly7. Engine coolant temperature sensor8. Bypass hose9. He ...

Water pump Troubleshooting

Troubleshooting Water Pump SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Flex Steer Description and Operation
Instruction Flex Steer is system to choose the three modes power steering depending on driver preference or driving conditions. • Display on the cluster but power steering is would not changed while operating the steering wheel. As a safety measures, mode is changed ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Auto Light Sensor Repair procedures
Inspection In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's input. The auto light control doesn't work if the pin sunlight supply (5V regulated powe ...