Hyundai Tucson: Cooling System / Water pump Components and Components Location
| Components |
| 1. Water pump pulley 2. Water pump 3. Water pump gasket 4. Water inlet fitting | 5. Thermostat 6. Water temperature control assembly 7. Engine coolant temperature sensor 8. Bypass hose | 9. Heater pipe & hose assembly 10. Throttle body coolant hose |
Radiator Repair procedures
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester.
2.
Apply a pressure of 93.16~122.58 kPa (0.95~1.25 kgf/ ...
Water pump Repair procedures
Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster.
2.
Remove the drive belt.
(Refer to Timing sys ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
4.
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
5.
Check that the resistance is within the specification.
Specifica ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Side Airbag (SAB) Module Repair procedures
Removal
The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly. (Refer ...
